Resource Library

TidyPen2™ is the 60-second sticky stuff remover that is built for benchtop cleaning! Dissolve and lift away almost any sticky residue with this powerful, natural cleaner.

The manufacturing challenge of COVID-19 is to provide greater social distancing recommended by health agencies while maintaining or improving capacity and productivity. Protecting workers is critical and can be done with factory automations that allow both safer worker distancing and manufacturing efficiencies. Automated parts cleaning with vapor degreasing answers this challenge.With one operator running the entire…

Cleaning flux residue after soldering (fluxes or solder pastes) from different manufacturers can be very tricky, but the Critical Cleaning Lab at MicroCare solves this complex problem. This situation arose when printed circuit boards were produced using a combination of different fluxes and solder pastes. This can be a real challenge because the different fluxes might react to…

This introduction to cleaning fiber optic networks is the first in a  three-part video training series. This video illustrates the the importance of maintaining perfectly clean ports, jumpers and splices in every fiber network.

MicroCare and our Critical Cleaning Lab lead the way on worker safety and regulatory compliance for critical cleaning processes. Still using smelly, old-style solvents? Or wasteful, high-pressure aerosol sprays? Are your cleaning fluids REACHand F-Gascompliant? Struggling with VOCsin today's low-VOC world? Or slow, expensive and energy-hungry aqueous cleaners? It's time to make the change to…

In this going green with vapor degreasing video, vapor degreasing is featured as an environmentally-sound way to clean printed circuit boards. Your manufactured electronic parts must be perfectly clean for next step processing. Vapor degreasing not only uses no water but it also consumes very little electricity. Plus it recycles cleaning fluid for hundreds of hours to cut waste. …